High Intensity Aviation Obstruction Light type B

Specification:

Application:

Widely used in the Air Force, civilian airports and obstacle free airspace. Mainly used in the electric power tower, the other place above the ground 150m also could use as the actual requirements accordingly.

Features:
The house of the light adopts high quality aluminium alloy, the light emitting surface use tempered glass, the structure is high strength, resistance to corrosion

● Use the special optical reflector design, the visual range further, angle more accurate, no light pollution.

● Light source adopts import high quality LED, lifespan up to 100,000 hours, low power consumption, energy efficiency and environment protection.

● Based on the single chip computer control, automatic identification sync signal, do not distinguish the main light and auxiliary light, and also could be controlled by controller.

● Same power supply voltage with synchronous signal, integrate in power supply cable, eliminate the damage by error installation caused.

● Used the photosensitive probe fit for the natural light spectrum curve, automatic control light intensity level.

● The circuit of the light has surge protection, so that the light is suitable to harsh environment

● Integral structure, protection lever of IP65

● GPS synchronizing function is available

CM-17 High Intensity Obstruction Light Type B Installation and Usage:

1. The identification of the line, lamps with one four-core cable: the brown and black line is the power line, the brown wire is the live wire(L), the black wire is the null line (N)， the blue is the signal wire(X)，the yellow-green wire is the ground line（）

2. Monitor controller panel: photocell , power , work, environment status , and 4 obstacle light failure indicator

3. Photocell: Testing environment brightness

4. Power indicator: Properly plugged into a power supply, light is lit

5. Work indicator: Monitoring system of work instructions, bright 1.5 seconds, 1.5 seconds

6. Status indicator: monitor system is operate model，flashing 1 times within 3seconds , it working on night with intensity 2000cd , flashing 2 times in a row within 3seconds ,it working on dawn or dusk with intensity 20000cd, flashing 3times in a row within 3seconds ,it working on day with intensity 270000cd

7. Faulty indicator : #1 to #4 lamps is four OBL

8. Connection: all lamps join up controller in parallel as follow

CM-17  High Intensity Obstruction Light Type B Installation Way

（1）Vertical way:

（2）Side elevation:

（3）Attention:

● All the lines must be connected correctly, otherwise may damage the light. Please look at the mark and introduction carefully.

● The power supply of this type of light is AC220V、50HZ/60HZ. Do not use other power supply, such as 380V, otherwise the light will be quickly damaged.

● In order to avoid being struck by lightning, the lamp is prohibited to install on the top or the edge of the iron tower (When necessary, it could add lightning arrester on the outside of the lamps).

● Don't aim the photocell switch to other light source;At the same time ensure photocell switch not be other objects.

● There will be a temperature rise when working, it is normal situation.

● When the light working, in order to avoid the dangerous, pls don’t open any part of the light body.

● This product is a sealing structure, pls don’t dismounting if you are non-professional technicians, Otherwise, we are not responsible for warranty repair.